Instruction Manual ProfiLux 4 / 4e
EN 2019-01-22 11
3.2.2 Powerbar Connection (ProfiLux 4 only)
The control cable of the powerbars (STDL4-4, Powerbar 6D) is connected to the Red RJ12
Western sockets S1-S4 and S5-S8 (from left to right). Our first generation GHL Dosing pump
unit (Doser with black housing and blue clips) can also be connected to this socket.
The function of each socket can be freely programmed to best fit your needs.
By default, for safety reasons, all sockets are deactivated!
If a digital powerbar is to be connected, the ProfiLux controller must be programmed
and set accordingly.
3.2.3 Interface for Mitras Lightbar/Slimline or RS232
The Black RJ45 Western socket can either be used to connect one or more Mitras Lightbar or
to connect to a PC using an additional special GHL RS232 cable.
3.2.4 Expansion Slots
The ProfiLux 4 / 4e allows you to modularly expand upon the existing system by using the 3
on-board Expansion Card slots. If you wish to add additional sensors, powerbars, dimmable
lamps, etc, you can install up to 2 ProfiLux Expansion Cards. Two of the slots are accessible
externally and used for connecting external accessories. The third expansion slot inside the
housing is solely for Expansion Cards which require no access from the outside. (E.g. PLM
PWC).
When these slots are full, you can further expand the ProfiLux 4 by connecting our Expansion
Box 2 to it. Doing so will grant you even more resources such as sensor connections, 1-10 V
interfaces and switching outputs.
3.2.5 PAB Ports
The two RJ45 Western sockets are PAB ports for PAB-devices such as
• Powerbar PAB
• ProfiLux Touch
• GHL Doser Slave
• Expansion Box 2
• SMS Module-PAB
Any PAB-device can be connected to this port. For more information, please refer to the
"Connection to PAB" section.
To Next Page
Loading...
Need help?
General
