GHL ProfiLux 4 - Help and Support Resources; Firmware Update Procedures; Technical Specifications and Measurements; Device Technical Specifications

Instruction Manual ProfiLux 4 / 4e
EN 2019-01-22 48
9 Additional Information
9.1 Help and Information
For help or further information, please visit our Support Forum or our Knowledge Base at
www.aquariumcomputer.com or contact your retailer.
9.2 Firmware-Update
The firmware of your ProfiLux 4 controller is constantly being further developed. If you want
to use new features that are not supported by your current firmware, you can update your
controller.
For the update, you need the latest firmware and the PC program GHL Control Center, both of
which can be downloaded free of charge from our homepage www.aquariumcomputer.com
in the download area (Support-> Downloads), as well as our USB cable.
Instructions for updating firmware can be found from our homepage.
10 Technical Data
The device and its accessories may only be used indoors. Moisture or excessive
humidity can lead to malfunctions or damage.
Power supply
Wide range power supply 100 – 240 VAC (50 – 60 Hz), < 0,6
A RMS
Input voltage
12 VDC
Environmental conditions
Operating temperature: 0°C - 40°C / 32°F – 104°F
Humidity: Max 80% rel. Humidity non-condensing
Current consumption
1.2 A max.
DANGER
• Be sure to back up your data before updating!
You can use the menu item
"Backup and Restore" -> "Transfer all settings from ProfiLux to file" and
load them again after the successful update via "Transfer from file to
ProfiLux".