Instruction Manual ProfiLux 4 / 4e
EN 2019-01-22 47
Thereafter, turn the box with gentle pressure and drive the screws back in again.
Restart the ProfiLux 4 / 4e in compliance with the following instructions.
7.2.4 Restart
Connect the sensors as well as the PAB cables to the ProfiLux 4 / 4e and restore the power
supply again.
Before restarting please observe the following precautions:
8 Warranty/Liability
You have a 2-year warranty beginning from invoice date. This applies to material and
manufacturing defects.
We guarantee that the supplied products correspond to the specifications and that the
products do not have material resp. manufacturing defects. For the accuracy of the manuals,
we do not guarantee damages of any kind which result from improper operation or from an
unsuitable environment. Furthermore, we do not take over warranty for damages that are
caused by a false connection or excessive humidity. We assume no liability for direct
damages, indirect damages, consequential damages and third party damages as far as it is
legally permitted. We do not take over guarantee that our product package corresponds to
the requirements of the buyer. Our warranty expires if the delivered original product is
damaged or modified.
DANGER
• If you change resources (add, remove, or exchange of modules) you
always must newly assign them to the ProfiLux Computer, so that all
sensor inputs and interfaces can be recognized and accepted by the
ProfiLux.
• The previously allocated resources may have been shifted through
the newly added modules. To avoid damage you must control the
assignments of the interfaces (i.e. level sensors, pumps and valves
for water change or dosing pumps) before recommissioning and
adjust them if necessary.
To Next Page
Loading...
