Instruction Manual ProfiLux 4 / 4e
EN 2019-01-22 38
Step 7: Disconnect from your P4 / P4e, press the icon
with the 3 dots (top right), then use your device to
connect to your home network.
Step 8: In the My Devices page, press Add device, select
the ProfiLux P4 / P4e, and give this connection any name
(P4 home). In the Host/IP field, type-in the assigned IP
address of your P4 / P4e (Refer to step 6 for example),
press Add, and then select the newly made connection
to connect.
6.3 Operating the Device via the Software GCC
Full device settings and functions are accessible via the software GHL Control Center (GCC),
which is available for download free of charge in the download area (support-> downloads)
of our homepage www.aquariumcomputer.com.
6.3.1 Requirements
You need the appropriate GHL Control Center for the firmware of the respective ProfiLux.
It runs on the operating systems Microsoft Windows Vista® and Windows 7®, Windows 8®,
Windows 10®.
The connection to the ProfiLux can be established via USB:
After successful installation, connect ProfiLux 4 to your PC using the USB cable. The driver is
installed automatically.
6.3.2 GCC General Information
With the Load button, the settings of the ProfiLux 4 are read out and the program displays are
updated. With Save, the settings you have made in the program are transferred to the device.
6.3.3 What can be set via GCC
With the PC program you can make almost all settings via mouse and keyboard, which
otherwise are carried out directly on the device.
There are the following exceptions:
• Therapy program
• Sensor calibration
To Next Page
Loading...
