GHL ProfiLux 4 - Connecting Powerbar Accessories

Instruction Manual ProfiLux 4 / 4e
EN 2019-01-22 19
pumps, consumer electronics, etc. False readings can be avoided by
following these precautions.
• Please also refer to the instruction manual for the individual
sensors.
5.4 Connecting Powerbars to ProfiLux 4 / 4e
For switching electrical loads with the ProfiLux 4 / 4e, you need a Powerbar, which is not
included in the scope of delivery of the controller.
The following Powerbar options are available:
• STDL4-4
• Powerbar 6D (Digital Powerbar)
• Powerbar 5.1 PAB
• Powerbar 6E PAB
All sockets are freely programmable in their function. The exact procedure can be found in
the supplementary "Programming manual ProfiLux 4" for download in the download area of
our homepage www.aquariumcomputer.com.
5.4.1 STDL4-4 (ProfiLux 4 only)
Plug the connecting cable of the STDL4-4, into the red connector sockets (S-Ports).
DANGER
• ProfiLux 4 / 4e cannot be connected to any of the older Powerbars of
ProfiLux or ProfiLux Plus (the previous models, until 2005)! This
would destroy the electronics.
• Powerbars are operated with mains voltage and are not waterproof.
This means that the socket strips must be protected against
moisture and splashing water!
TIP
• If you have connected a Powerbar, you should label the sockets
with a water-proof pen or sticker with the corresponding numbers
and their function.