Instruction Manual ProfiLux 4 / 4e
EN 2019-01-22 16
5 Activation
5.1 Installing the ProfiLux 4 / 4e
The device must be protected from water at all times!
Mount the controller in a water-protected area. When selecting the mounting material, make
sure that you have adequate sizing and stability. Make sure that the unit cannot fall into the
water during assembly or normal use.
If the device is placed inside an aquarium cabinet, make sure that it is placed in an area free
from splashing water; moisture or liquids that can penetrate.
5.2 Important Operating Instructions
ProfiLux 4 / 4e as well as its accessories (e.g. Powerbar) are destroyed by excess
moisture or too high atmospheric humidity - Please observe the technical data and
notes below!
To ensure safety and safe operation, the following regulations must be followed! In the case
of non-compliance, warranty claims expire, the manufacturer also rejects any responsibility
or liability for damage!
DANGER
• Never leave your aquarium or terrarium unsupervised for an
extended amount of time.
• The ProfiLux can assist you with many tasks and inform you about
error conditions (For example, via email or SMS) - it can in no-way,
replace regular personal supervision and on-site checks-ins.
• The maximum amount of time without personal view depends on
how long your aquarium, terrarium, or pond can survive without
significant damage, even when errors occur.
• Always remember that each technology can fail and malfunctions
can never be ruled out!
Power failures, incorrect settings, damage (For example, by water or
overvoltage) or simply an unexpected operating situation can lead
to fatal damage.
• The manufacturer disclaims any liability for (consequential)
damages or losses which might arise in connection with the use of
the ProfiLux System extent legally permissible.
To Next Page
Loading...
Need help?
General
