Instruction Manual ProfiLux 4 / 4e
EN 2019-01-22 17
Powered equipment and water can become a dangerous combination if precautions are not
taken. It is therefore essential to supply power to all mains-operated devices which are
operated in the aquarium or in the vicinity of the device via a residual current circuit breaker!
The Powerbar is operated with mains voltage and is not waterproof. This means that the
socket strip must be protected against moisture and splashing water! Please take note of this
when choosing the installation location.
In order to avoid any danger, all mains-operated devices must be disconnected from the
mains; all plugs must be disconnected! When working in the basin. It can never be ruled out
that a heating element, a pump, or a luminaire is defective.
For safety reasons, the use of a controlled heater is recommended. This should be adjusted
that it switches off slightly above the desired temperature. Thus, the temperature can be
controlled further, but a possible malfunction of the control does not lead to an overheating
of the aquarium.
• Please ensure good access to the connections of the device
• Please consider the maximum cable lengths of the connected PAB
cables, sensors, Light Bar etc. when selecting the installation site
• Additional sensor cable extensions (BNC2 or VTN cables) and PAB
cables are available in different lengths to fit your needs. They are
available online in our GHL Store (For US customers, GHL USA Store).
• To ensure proper operation, the connection cables should never be
kinked, crimped, or positioned in an unsuitable way.
DANGER
On all cables and lines leading out of the aquarium water can run
downwards. Therefore, they must be routed in a way that no water can
enter electrical or electronic parts! This could be accomplished by
arranging so called drip loops at all cables and lines.
To Next Page
Loading...
