Instruction Manual ProfiLux 4 / 4e
EN 2019-01-22 12
3.2.6 Level Sensor Connections
Level sensors are used for monitoring and maintaining set water levels and is also used for
leakage detection purposes. These sensors can be connected to the Level ports (Mini DIN
sockets: Level 1 & 2 Purple, 3 & 4 Green). Since these are sockets with double allocation, you
can also use a splitter cable (Y-cable PL-LY; not included) to connect two level sensors to a
single Level sensor port and control them independently.
3.2.7 1-10V Interfaces
Devices that use 1-10V interfaces are connected to the three Yellow RJ12 Western sockets
L1/L2, L3/L4, L5/L6 (Right to left).
1-10V interface devices include:
• Dimmable tubular GHL Lightbars ALB
• Dimmable Effect-LED-Light Mitras-Simu-Stick
• Dimmable sockets
• Controllable heating or cooling (e.g. Propeller Breeze)
• Controllable stream pumps
Each of these ports include two independent 1-10V interfaces and associated relay control
outputs. If necessary, each port can be extended with the splitter cable -YL2, available in
different lengths.
3.2.8 Power Failure Monitor/ Line Monitor Port
A mains voltage monitor (12V plug-in power supply with jack plug) can be connected to this
connection.
3.2.9 USB Connection
The ProfiLux 4 Controller can be connected to a PC via USB cable. This means that all settings
can be configured comfortably using GHL Control Center. GCC software can be downloaded
free of charge from our website’s download area.
3.2.10 GHL Control Pad Connection
A GHL Control Pad can be connected here.
3.2.11 DCF Receiver Connection
A DCF77 Receiver from GHL can be connected to this RJ10 Western socket. The DCF Receiver
must be activated so that ProfiLux 4 / 4e is able to decode and use the time transferred from
the receiver.
To Next Page
Loading...
