Omnia Setup with Wizard - New Configuration Omnia PCB
MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020 Page 5-11
7 Once the configuration is complete, click Next.
8 If the Media (Applause) was selected, the wizard will open the configuration page as shown in
Figure 5-15.
Field Configuration Settings
Mode Set the Media mode to Applause Media System.
Side A - Terminal ID Set the Terminal ID to match the actual CRIND ID programmed in the unit
p
rogramming or fueling position.
Side A - Pump ID Set the Pump Monitor ID to match the actual pump ID programmed in th
e unit
programming. (If connected to Passport POS system, all IDs will be 7 for side A and
11 for side B).
Side B - Terminal ID Set the Terminal ID to match the actual CRIND ID programmed in the unit
p
rogramming or fueling position.
Side B - Pump ID Set the Pump Monitor ID to match the actual pump ID programmed in th
e unit
programming. (If connected to Passport POS system, all IDs will be 7 for side A and
11 for side B).
Idle Loop Enabled Enable or disable the Idle Media. Select to turn ON if you want
the media to run when
the unit is in idle condition. If you do not want media to run when the unit is idle, set as
disable.
Idle Loop Delay(s) Number of seconds of delay before starting idle media loop.
Idle Loop Delay From Busy Number of seconds of delay before starting idle media loop after b
usy loop.
Busy Loop Enabled Turn the Busy Media ON or OFF. Select to turn ON if you want the
media to run when
the unit is in busy condition. If you do not want the media to run when the unit is busy,
set as Delay.
Busy Loop Delay(s) Number of seconds to delay before star
ting the busy media loop.
Source Server
Server IP Applause server IP address should be changed (recommended 10.5.55.66).
Volume Video volume 1-100
Note: If Idle Media is enabled, media advertisements can r
un during a POS application download. Gilbarco
recommends disconnecting the Applause Media System Site Server or waiting to turn ON the Idle Media until
the units are fully up and running with the POS.
To Next Page
Loading...
Need help?
General
