MDE-5369G FlexPay™ IV (with Omnia V04.07) Programming and Service Manual · March 2021 Page 7-5
PIP3 Connections Troubleshooting
PIP3 Connections
Ensure that the loopback jumper is in place on the B side of the PIP3.
Figure 7-5: PIP3 Loopback Connector
Figure 7-6: Loopback Connector Location on PIP3 (B Side Only)
PIP3
Loopback
Connector
Installation
Location
Note: This PIP3 Loopback Connector must be installed before dispenser power is
applied.
Pin 1
Pins Connection Status
1-5 Open
6 and 7 Shorted
Note: If a M14339A002 is not available, you can use 0.1-inch jumper.
8 Open
To Next Page
Loading...