42
Fryer Operation
GBF-70 Fryer
4.01.7 Manually Operating the Basket Lifts (If Equipped)
x 2
To cancel a running cook cycle press the [CLEAR] key once, then press it again
to cancel • OR • press [<4] to continue cooking.
4.01.6 Cooking Cycle General Overview - continued
NOTE:
▪ Lift Switch on control panel must be in the [LIFT] position.
▪ As a safeguard against attempting to cook product in oil that is not yet at the proper temperature, manual
operation of lifts is disabled while fryer is in the PREHEAT phase.
▪ Once activated, a lift cannot be actuated again for approximately 20 seconds.
Press the [BASKET] key once
Use keypad [2] UP & [8] DOWN keys to select raise or
lower basket lift.
Press [CLEAR] to Cancel the operation.
Use keypad to select side
[4]=Left [5]=Both [6]=Right
When STIR ALARM is active, an audible alarm sounds at a specific time in the cooking cycle to signal the operator it
is time to stir the cooking product, which helps to promote even cooking and prevent sticking. The feature must be
enabled in User Settings (Section 4.01.10) and the parameter must be set. [STIR ALARM %] = amount of elapsed
time before the alarm sounds. e.g. if [STIR ALARM %] = 60, during a 10 min. cook cycle, the alarm will sound after 6
mins. of cooking time have elapsed.
Factory‐set default: [STIR ALARM ENABLE] = ON • [STIR ALARM %] = 62.
A specific menu item STIR OVERRIDE setting can override the [STIR ALARM ENABLE] setting, see Section 4.01.5.1.
When the cooking cycle time is complete, an alarm will sound and the message “DONE COOKING ‐ (LEFT) (RIGHT)
or (BOTH)” is displayed. If fryer is equipped with basket lifts, the appropriate cook basket is automatically lifted
from the oil. Pressing the [ALARM] key silences the alarm and the fryer re‐enters READY state, ready to cook the
next load of product.
To Next Page
