45
GBF-70 Fryer
4.01.11 PASSWORD Protection
4.01.12 Power Up Procedure
It is possible to add PASSWORD protection for certain controller settings. This feature is a FACTORY SETTING that is
typically DISABLED. If PASSCODE ENABLE is set to [ON], the user is prompted to enter a password before
performing many controller operations.
If you desire to have password protection enabled, or have questions concerning this feature, call Giles Technical
Services at 800.554.4537 to request the passcode and instructions as to how to enable the feature.
1. Ensure that the Heat Switch ① is in the [OFF] position.
2. Place the Power Switch ② in the [ON] position.
The green POWER Light ③ will illuminate and the
controller powers up and then sounds an alarm
tone. The message “POWER FAILURE [PRESS
START TO PREHEAT]” is shown on the Upper
Display ④. This is normal
, as a safeguard to
prevent the fryer from beginning to heat after
power interruptions until it is attended by an
operator. Press the [START] key ⑤ to silence the alarm and place fryer into PREHEAT
phase. The Upper Display shows the current cook setting (last used). The controller HEAT
indicator adjacent to the Lower Display turns ON, but until the Heat Switch ① is placed in
the [HEAT] position, heating elements will NOT be energized.
DO NOT place Heat Switch in the [HEAT] position until fry vat has been filled with cooking
oil. See Section 4.02, Cooking Procedures.
2
1
4
3
5
NAME DESCRIPTION RANGE DEFAULT
LANGUAGE Sets the controller language
English‐Spanish‐
French
English
COOK ON MENU
SELECT
*
If [ON], selecting a MENU # will automatically begin the
cooking cycle. Reduces the number of keystrokes needed to
start a cook cycle.
ON ‐ OFF OFF
[0] KEY EXTRA TIME
If [ON], operator can add extra time to cook cycle (after or
during the cycle) by pressing [0] + the number of minutes to
add.
ON ‐ OFF OFF
* Setting is available ONLY on dual‐timer controllers.
4.01.10 User Settings - continued
Fryer Operation
To Next Page
Loading...
