44
Fryer Operation
GBF-70 Fryer
4.01.10 User Settings
Press the
[TIME] key
9999
To view current settings, use numeric keypad [<4] • [6>] to scroll through
table and display each setting.
To exit User Settings menu, press the [CLEAR] key.
Press the
[START] key
NOTE:
The message “TOO LOW” or
“TOO HIGH” will be displayed if a
value being entered is outside the
allowable range and would cause
a controller error.
Input
Settings are shown on the Upper Display.
Settings may be edited by the user ... access the User Settings menu is as follows:
• To edit a displayed setting, press the [EDIT] key.
• Use numeric keypad [2] ‐ [8] (up/down) to change the value.
• Press [EDIT] again to save the new setting.
NAME DESCRIPTION RANGE DEFAULT
TEMP SCALE Temperature scale °F or °C °F
FORCE FILTER
When ON, forces user to filter oil after number of cook cycles
in FILTER COUNT are complete ... locks‐out fryer until filtered.
ON ‐ OFF ON
FORCE FILTER
SNOOZE
When ON, allows (1) more cook cycle after FILTER COUNT is
exceeded with FORCE FILTER = ON.
ON ‐OFF OFF
FILTER COUNT Number of cook cycles before user is required to filter. 1 to 20 4
GUARD BAND
Cooking not allowed if oil temperature is outside of the
setpoint by amount of guard band
1 to 990 900
MAX SETPOINT Maximum oil setpoint allowed. 32°F to 375°F 350°
AUTOCOOL After a specified amount of time, unit will go into COOL mode. ON ‐ OFF OFF
AUTOCOOL TIME
(MINUTES)
If AUTOCOOL = ON, after fryer is idle for the amount of time
specified, the unit enters COOL mode.
1 to 510 minutes 30
AUDIBLE ALARM
(SECONDS)
Duration of the audible alarm in seconds, automatically silences
after this amount of time..
5 to 120 seconds 10
COOL TEMP Temperature setting of COOL mode 200°F to 350°F 275°F
BOIL TEMP Temperature setting for BOIL OUT mode 185°F to 208°F 200°F
FILTER RESET Temperature that resets fryer from FILTER MODE. 200°F to 325°F 290°F
BOIL OUT TIME Time (in minutes) for BOIL OUT mode 1 to 45 minutes 30
STIR ALARM
ENABLE
If ON, sounds the STIR ALARM during a cook cycle. ON ‐ OFF ON
STIR ALARM %
When STIR ALARM = ON, the alarm sounds after this % of
cooking cycle has elapsed.
10% to 90% 62%
KEY BEEP ENABLE If ON, audible sound is generated with each keystroke. ON ‐ OFF OFF
Continued on Next Page
To Next Page
Loading...
