GKB 4CH/8CH VFire Server
126
n Record Quality – the record quality for this camera. Press +/- buttons to select
the value (1-9, with 1 the lowest (rough) quality, 9 the highest (fine) quality).
n Event Record IPS – the IPS (Images Per Second) for this camera if certain event
(Motion, Alarm) occurs for this camera. This camera will be recorded at this
rate for Post-record time since the event occurs. (Please refer to the following
sections for Post-record time.) Press +/- buttons to select the value (0 – 25
(PAL) / 30 (NTSC), discrete).
n Pre-record IPS – the pre-record IPS for this camera if certain event (Video Loss,
Motion, Alarm, Fire/Smoke) occurs for this camera. This camera is recorded
at this rate for Pre-record time before the event occurs. (Please refer to the
following sections for Pre-record time.) For this NVR, the value is always the
same as Event Record IPS.
n Normal Record IPS – the normal record IPS for this camera. This camera will
be recorded at this rate if no event occurs. Press +/- buttons to select the
value (0 – Pre-record IPS for this camera, discrete). Please note that for High
compression ratio in Pre-Camera setup, Normal Record IPS is always the same
as Event Record IPS.
n Real event recording – present the real event recording when camera's Internet
connection is normal.
To Next Page
Loading...