GKB 4CH/8CH VFire Server
128
n Pre-record – to define how long before fire/smoke is detected this camera shall
be intensively recorded at Pre-record IPS. Press +/- buttons to adjust the
value (0-10 seconds, discrete). Please note that the actual pre-record time
may be shorter than the value set if the total size of the pre-record pictures
exceeds the pre-record buffer size of the system.
n Post-record – to define how long after fire/smoke is detected this camera shall
be intensively recorded at Event Record IPS. Press +/- buttons to adjust the
value (0 second - 60 minutes, discrete).
n Alarm Out – to define which Alarm Output will be triggered when fire/smoke of
this camera is detected. Press +/- buttons to select none (N/A) or one of the
Alarm Outputs (NC (1), NO (2)).
n Fire/Smoke detection – to define the flame line/smoke line/mask area.
(Disable).
n Buzzer – to activate the internal Buzzer or not when fire/smoke of this camera
is detected. Press ENTER or +/- (Mouse: Left click) to check/uncheck this item.
The default setting is “ˇ” - checked.
n Log – to log to event logs or not after fire/smoke is detected. Press ENTER or
+/- to check/uncheck this item. The default setting is “ˇ” - checked.
n Screen Message – to display the event message on the screen or not. Press
ENTER or +/- to check/uncheck this item. The default setting is “ˇ” - checked.
n Notification (include E-mail/Push Alarm) – to send the event e-mail/push alarm
to remote station or not. The e-mail/push alarm will be sent to the
predefined/registered receivers at the moment when the event is triggered.
Press ENTER or +/- to check/uncheck this item. The default setting is “–” -
unchecked.
n FTP – to send the recorded event video/audio files to FTP server or not. Press
ENTER or +/- to check/uncheck this item. The default setting is “–” -
unchecked.
To Next Page
Loading...