GKB 4CH - Page 64

GKB 4CH/8CH VFire Server
64
n Setup Alarm – to enable the user to do Alarm Setup if “checked”. Press
ENTER or +/- (Mouse: Left click) to check/uncheck this item.
n Setup Main/SEQ Display – to enable the user to do Main/SEQ Display Setup
if “checked”. Press ENTER or +/- (Mouse: Left click) to check/uncheck this
item.
n Setup Scheduled Record – to enable the user to do Scheduled Record Setup
if “checked”. Press ENTER or +/- (Mouse: Left click) to check/uncheck this
item.
n Setup HDD – to enable the user to do HDD Setup if “checked”. Press
ENTER or +/- (Mouse: Left click) to check/uncheck this item.
n Setup Password – to enable the user to do Password Setup if “checked”.
Press ENTER or +/- (Mouse: Left click) to check/uncheck this item.
n Setup System – to enable the user to do System Setup if “checked”. Press
ENTER or +/- (Mouse: Left click) to check/uncheck this item.
n Setup RS-232/422/485 – to enable the user to do RS-232/422/485 Setup if
“checked”. Press ENTER or +/- (Mouse: Left click) to check/uncheck this
item.
n Setup Network – to enable the user to do Network Setup if “checked”.
Press ENTER or +/- (Mouse: Left click) to check/uncheck this item.
n Setup Factory Defaults – to enable the user to restore factory defaults to all
setup related configurations if “checked”. Press ENTER or +/- (Mouse: Left
click) to check/uncheck this item.
n Software Upgrade – to enable the user to upgrade NVR software if
“checked”. Press ENTER or +/- (Mouse: Left click) to check/uncheck this
item.
n Shutdown – to enable the user to shutdown the NVR if “checked”. Press
ENTER or +/- (Mouse: Left click) to check/uncheck this item.