GME TX6600PRO - Belt Clip Attachment; General Operation Guide; Key Operations and Feedback

TX6600PRO INSTRUCTION MANUAL
12
BELT CLIP
To attach the belt clip:
1. Position the clip on the rear of the radio.
2. Attach using the screws supplied.
GENERAL OPERATION
Please refer to the diagrams on the ‘Controls’ page for a general description of the
controls and keys.
OPERATION OF THE KEYS
Where the instruction says Press you should briey press and release the key to
activate its feature. Where the instruction says Hold you should press and hold
the key for about 2 seconds to activate its feature.
Key Beeps
If the BEEP option in your radio’s menu is enabled, a beep will be heard whenever
a key is pressed. A high beep indicates the key’s function has been activated
successfully. A rising two-tone beep indicates a function has been switched On
while a falling two-tone beep indicates the function has been switched O. A
falling two-tone beep will also be heard when a key’s function cannot be selected.
NOTE: If Channel Announce is switched On, beeps will not be heard when rotating
the Channel knob or pressing the keys. Instead, a voice will be heard
announcing the channel.
Function Key
Most keys have multiple functions that are printed on the key in white and red.
The primary key functions are printed in white. There are usually two operations
related to each primary function and these can be accessed either by briey
pressing the key or by holding the key.
To access the secondary functions printed in Red you need to rst press the
MENU
F
key. ‘F’ will be displayed to indicate you are in Function mode. While ‘F’ is
displayed, press the desired Red key within 10 seconds to activate that function.