GME TX6600PRO - Scan Group Selection

TX6600PRO INSTRUCTION MANUAL
19
To start Triple Watch
1. Choose your selected channel using the Channel knob or press the
keys.
2. Hold the Red key on the top panel to activate Triple Watch.
3. TW - xx will appear (where xx will alternate between your two
Priority Channels) and the icon will animate. The radio is now
watching all three channels.
NOTE: When Triple Watch is active, you can change the selected channel at any
time by rotating the Channel knob or pressing the keys. Your radio will
continue to monitor your two Priority Channels as well as your newly selected
channel.
To exit Triple Watch
1. Press the Red key. Triple watch will stop and the radio will return to
normal operation.
SCAN GROUPS
The OS/GS key is used to select a scan group for scanning. Available scan groups
are Open Scan 1, Open Scan 2, Group Scan and Network Scan.
To cycle between scan groups
Briey press the
MENU
F
key followed by the
SCAN
OS/GS
key. OPEN1, OPEN2, GROUP or
NETWK will be displayed briey.
Please refer to the SCANNING section for further details on the operation of each
scan group.
NOTE: Network scan (NETWK) is disabled by default and if required will need to
be enabled through the radio’s menu. It will not appear under the OS/GS key until
it has been enabled (see NETWORK SCAN later in this manual).