TX6600PRO INSTRUCTION MANUAL
46
NOTE: You don’t need to enable the QUIET mode to use SelCall. If you prefer to
listen to all incoming conversations, you can still receive SelCalls on any channel
even if the QUIET mode is not enabled.
SelCall Contacts
Your TX6600PRO supports up to 48 SelCall contacts. Contacts can be saved and
recalled using the contact list or alternatively you can manually enter and dial a
SelCall Ident directly through the CALL menu.
Ident or Alpha Name
SelCall Idents stored in your contact list can be allocated a 6 letter ‘Alpha’ name.
If an incoming SelCall matches one of those in your radio’s contact list, your radio
can be set to display the name instead of the Ident. This makes it easier to identify
the calling radio.
The following characters are available for use in Alpha Names.
PUNCTUATION NUMBERS LETTERS
– + * , _ 1 2 3 4 5 6 7 8 9 0 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
CALL MENU
The CALL menu provides access to all SelCall options. To access the SelCall
options:
1. Press the
CALL
LOCK
key. The SelCall sub-menu will be displayed.
2. Rotate the Channel knob or press the keys to cycle through
the following sub-menu options:
• SAVED: Review, Edit or Save SelCall Idents in your contact list
• OWNID: Review or Edit your radio’s own SelCall Ident
• DIAL: Manually enter a SelCall Ident for sending
• RECNT: Recall recently received or sent SelCall Idents
Editing your Own SelCall Ident
Your radio is shipped with its own unique 5 digit SelCall ID already programmed. If
you wish you can change this to one of your own preference.
Note the new Ident you choose must have 5 digits.
To Next Page
Loading...
