GME TX6600PRO - Page 65

TX6600PRO INSTRUCTION MANUAL
61
NOTE: New channels are automatically loaded with a frequency of 403.000 MHz.
Once created, you will need to edit the frequency to suit your requirements.
Editing the Frequency of a Receive-only Channel
IMPORTANT: Before editing or reviewing any channel properties, check that the
desired channel number is displayed.
• If you have only just created a new channel, the desired channel
number should already be displayed.
• If not, you will need to exit the menu (select EXIT and hold the
MENU
F
key). You can then select the desired channel before re-entering the
menu and navigating back to the CHAN sub-menu.
NOTE: You cannot remove (delete) a CB channel nor can you edit any of the
properties of a CB channel although you can view them.
While in the CHAN sub-menu:
1. Rotate the Channel knob or press the keys to cycle through
the sub-menu until RXFRQ is displayed.
2. Press
MENU
F
. The current receive frequency for the selected channel is
displayed.
• If the channel is a new receive-only channel, 403.000 is
displayed otherwise the last entered frequency is displayed.
NOTE: 403.000 MHz is the lowest frequency you can program
into the TX6600PRO.
3. Hold the
MENU
F
key to edit the frequency. The cursor will ash in the
10 MHz digit position.
4. Press the keys or rotate the Channel knob to adjust the
frequency in 10 MHz steps between 403 and 520 MHz.
5. When the desired value is displayed, press
MENU
F
to select. The
ashing cursor will move to the 1 MHz digit position.
6. Repeat the process to adjust the frequency in the 1MHz, 100 kHz and
10 kHz positions. Note that when adjusting the 10 kHz position the
frequency will change in 12.5 kHz steps.
7. When the desired frequency is displayed, hold
MENU
F
to save. The entire
frequency will ash as it is saved. Press
MENU
F
to exit the menu.