GME TX6600PRO - Page 68

TX6600PRO INSTRUCTION MANUAL
64
Viewing the Transmit Frequency
While in the CHAN sub-menu:
1. Rotate the Channel knob or press the keys to cycle through
the sub-menu until TXFRQ is displayed.
2. Press
MENU
F
.
i. If the channel is a CB channel, the transmitter frequency for the
selected channel is displayed.
ii. If the channel is a Receive-only channel, N/A is displayed.
3. Press
MENU
F
to exit the menu.
Viewing the Receiver CTCSS/DCS Tone Frequency
While in the CHAN sub-menu:
1. Rotate the Channel knob or press the keys to cycle through the sub-
menu until RXTONE is displayed.
2. Press
MENU
F
.
i. If the channel is a CB or Receive-only channel and no tone
is enabled under CTCSS/DCS in the main menu, CTCSOF is
displayed. Otherwise, GLOBAL is displayed to indicate the
channel is using the CTCSS/DCS tone dened under CTCSS/DCS in
the main menu.
ii. If the channel is a Private channel and no tone is enabled,
CTSCOF is displayed. Otherwise the CTCSS/DCS tone the channel
is using is displayed as CTCSxx or DCSxxx.
3. Press
MENU
F
to exit the menu.
Viewing the Transmitter CTCSS/DCS Tone Frequency
While in the CHAN sub-menu:
1. Rotate the Channel knob or press the keys to cycle through
the sub-menu until TXTONE is displayed.
2. Press
MENU
F
.
i. If the channel is a CB or Receive-only channel and no tone
is enabled under CTCSS/DCS in the main menu, CTCSOF is
displayed. Otherwise, GLOBAL is displayed to indicate the
channel is using the CTCSS/DCS tone dened under CTCSS/DCS in
the main menu.