GME TX6600PRO - Page 70

TX6600PRO INSTRUCTION MANUAL
66
Viewing the SelCall Setting
While in the CHAN sub-menu:
1. Rotate the Channel knob or press the keys to cycle through
the sub-menu until SELCALL is displayed.
2. Press
MENU
F
.
i. ON will be displayed if a CB or Private channel is congured to
receive and respond to SelCalls.
ii. OFF will be displayed if the channel is a Receive-only channel or
is congured to not receive or respond to SelCalls.
3. Press
MENU
F
to exit the menu.
Displaying Alpha Names on Receive-only channels
When a name is applied to a Receive-only or Private channel, the menu’s display
(dSP) setting is automatically set to display the name (CHNAME) under the
channel number whenever a receive-only or Private channel is selected. This
setting is separate to the menu’s display setting for CB channels. i.e. you can have
the channel name displayed on receive-only and Private channels and still have
the signal meter displayed on CB channels.
If a name has not been applied to any Receive-only or Private channels the radio
will default to displaying the Signal meter (S-MET) setting.
You can use the menu to manually change the display setting on Receive-only and
Private channels at any time.
The default display setting may also be congured from the dealer software.
Scanning on a Receive-only Channel
Receive-only and Private channels can be programmed into your Open or Group
scan groups in the same way as your normal CB channels. Receive-only channels
cannot be programmed into your Network Scan group.
To add a Receive-only or Private channel to your scan group, simply select the
required scan group (Open1, Open2 or Group), select the Receive-only or Private
channel then press and hold the
SCAN
OS/GS
key until the radio beeps. will be
displayed on that channel. For more details on scanning, see the section on
‘Scanning’ in this manual.