GO Systemelektronik BlueBox User Manual

BlueBox
GO Systemelektronik GmbH Faluner Weg 1 24109 Kiel Germany Tel.: +49(0)431-58080-0 Fax: -58080-11
Page 57 / 77
www.go-sys.de info@go-sys.de
8.2.3 Sensor menu
Example oxygen
From this menu you can determine the settings of a connected sensor and calibrate it (if necessary), repre-
sent their values over time and see the current settings of the sensor. For the specific settings of the con-
nected sensor, please refer to the description of the sensors.
09:19:39
10.07.10
<–
Oxygen
Interval
Average
Calibration
Table
Diagram
Info
Selected
09:19:39
10.07.10
<–
pH value
Interval
Average
Calibration
Table
Diagram
Info
Selected
Cal. mode
Main menu 8.2
Switches to the Sensor menu of the sensor, which is displayed in the Parameter
display.
Sensor list 8.2.2
Switches to the input of the measurement interval.
Switches to the input of the measurement average.
Switches to the calibration menus.
Switches to the table display.
Switches to the diagram display.
Switches to the sensor information.
Selects the sensor for the multiple parameter display or not.
see also 8.2.1.6 Display
Switches to the menu for the selection of the calibration mode.
Only visible with sensors, in which a selection of calibration mode is possible.
Switches back to the sensor menu.
Sensor
Ox ygen
Interval
Average
Calibration
Table
Diagram
Info
Selected
Selected
Cal. mode
<–

GO Systemelektronik BlueBox Specifications

General

Brand	GO Systemelektronik
Model	BlueBox
Category	Control Unit
Language	English