GRAPHTEC LABELROBO LCX603 - Page 60

LCX603-UM-651-9370 2-52
2 Setup
(6) PresstheF2Key(DENSITYHEAD3),thefollowingmenuisdisplayed.
(PresstheF4Keyifadjustingforthehead1.)
(PresstheF3Keyifadjustingforthehead2.)
HEAD 3 RIB B O N T Y P E
< R ESI N >
SELE C T:
↑ ↓
YES: E NTER N O :ESC
(7) PresstheENTERkey.
HEAD 3 DEN S I TY
<42>
SELE C T:
↑ ↓
YES: E NTER N O :ESC
(8) Adjustthenumericalvalue(42to48)withthePOSITIONkeys(▲▼)andsetthedensity.
PresstheENTERkeyafterthedensityisadjusted,thedisplayreturnstothepreviousscreen.
PresstheESCkeytoreturntothepreviousscreen.
PresstheLOCALkeytoreturntoREADYstatus.
Adjusttheprintingdensityfromtheprintingresultoftestpatternforallprinthead.
Ifaprintingresultseemstorub,graduallyincreasetheprintingdensity.
Iftheribbonstickstoahead,thewrinkleisappeared,decreasetheprintingdensity.
Iftheverticalwhitelinesareappearedontheprintingresult,thereisdustontheprintheadsorthe
platenrollers.
Cleantheprintheadortheplatenroller,andthenperformtheprintingtestagain.