Grizzly G1026 User Manual

-14-
Model G1026 (Mfd. Since 10/13)
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 Qty
• Shaper Unit ................................................ 1
• Magnetic Switch ......................................... 1
•
FOR/REV Switch ........................................ 1
Box 2
•
Fence Assembly ......................................... 1
•
Fence Faces ............................................... 1
Box 3:
•
Handwheel ................................................. 1
•
Miter Gauge ............................................... 1
•
Handle for Handwheel ............................... 1
•
Spindle
1
⁄2" .................................................. 1
•
Spindle
3
⁄4" .................................................. 1
• Spindle 1" ................................................... 1
•
Spindle Nut
1
⁄2" ........................................... 2
•
Spindle Nut
3
⁄4" ........................................... 2
• Spindle Nut 1" ............................................. 2
•
Spacers* ................................................... 18
•
Draw Bar & Nut .......................................... 1
•
Spindle Wrench Set.................................... 3
•
Safety Guard .............................................. 1
•
Safety Guard Shaft .................................... 1
•
Starting Pin ................................................ 3
•
Hold Downs ................................................ 4
•
Hold Down Bars ........................................ 2
•
Hold Down Brackets .................................. 4
•
Hex Wrench 5mm ....................................... 1
•
Spindle Washer
1
⁄2" .................................... 2
•
Spindle Washer
3
⁄4" ..................................... 2
• Spindle Washer 1" ...................................... 2
•
Hardware Bag ............................................ 1
—Set Screw
5
⁄16"-18 x
3
⁄8" ........................... 4
—Hex Nuts
5
⁄16"-18 ..................................... 6
—Flat Washer
5
⁄16" ...................................... 4
—Flat Head Screw
5
⁄16"-18 x 1
1
⁄2" ............... 4
—Hex Nuts
1
⁄4"-20 ...................................... 2
—Flat Washers
1
⁄4" ..................................... 4
—Knob Bolts
1
⁄4"-20 x
1
⁄2" ........................... 2
—Flat Hd Screws
1
⁄4"-20 x 1" ...................... 2
•
Extension Bracket w/Lock knob ................. 1
•
Lock Handle ............................................... 1
•
Guard Extension Bar .................................. 1
•
Shaft Mount Bracket w/Set Screw .............. 1
•
Top Plastic Safety Guard ............................ 1
•
Front Steel Safety Guard ............................ 1
•
Padlock with Keys (Pre-Installed) .................
Note: Refer to Page 38 for a detailed listing of
spacers supplied.

Grizzly G1026 Specifications

General

Brand	Grizzly
Model	G1026
Category	Power Tool
Language	English