Model G1026 (Mfd. Since 10/13)
-41-
SECTION 6: MAINTENANCE
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Cleaning the Model G1026 is relatively easy.
Vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth. Blow
out hard-to-reach areas with compressed air, and
keep the spindle clear of wood dust and chips.
If any resin has built up, use a resin dissolving
cleaner to remove it.
Protect the unpainted cast iron table by wiping
it clean after every use—this ensures moisture
from wood dust does not remain on bare metal
surfaces. Keep the table rust-free with regular
applications of products like G96
®
Gun Treatment,
SLIPIT
®
, or Boeshield
®
T-9.
Cleaning &
Protecting
Figure 63. Boeshield® T-9 spray.
G2871—Boeshield
®
T-9 12 Oz. Spray
G2870—Boeshield
®
T-9 4 Oz. Spray
Perfect for unpainted cast iron surfaces, this
ozone-friendly protective spray penetrates deep
and really holds up against corrosive environ-
ments. Lubricates metals for months and is also
safe for use on most paints, plastics, and vinyls.
Developed by Boeing engineers for aircraft appli-
cations—this is the best!
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check
• Loose mounting bolts.
• Worn or damaged cutters.
• Clean/lubricate table and miter gauge.
• Worn or damaged wires.
•
Any other unsafe condition.
Weekly Maintenance
• Clean/vacuum dust buildup from in and
around cabinet and off motor.
Monthly Check
• Check/lubricate spindle slide and leadscrew
(see Page 42).
• Check V-belt condition and tension (see
Page 43).
Annually
• Replace V-belt.
Schedule
To Next Page
Loading...
Need help?
General
