Model G1026 (Mfd. Since 10/13)
-17-
Assembly
Most of your Model G1026 has been assembled
at the factory, but some parts must be assembled
or installed after delivery.
To assemble the shaper:
1.
Remove the motor cover from the shaper
cabinet by removing six screws that hold it in
place.
2.
Remove the six hex bolts, hex nuts and flat
washers and the two motor braces shown in
Figure 8.
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
listed items. To ensure the assembly process
goes smoothly, first clean any
parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
3. Re-install all the fasteners removed in Step 2.
Figure 8. Motor braces and hex bolts.
Hex
Bolts
4. Slide the grommet plate, FOR/REV switch,
and magnetic switch between the motor and
the cabinet (see Figure 9) and remove the
grommet plate and switches from the cabinet.
Figure 10. Securing grommet to motor cover.
5.
Re-install the motor cover.
6. Install the grommet plate, as shown
in Figure 10, using the screws and nuts
already mounted in the motor cover.
Figure 9. Removing magnetic switch from
cabinet.
Grommet
Plate
Motor
Braces
To Next Page
Loading...
Need help?
General
