To Next Page

To Previous Page

-50-

Model G1026 (Mfd. Since 10/13)

Adjusting the Gibs

Tools Needed Qty

Open-End Wrench 12mm .................................. 1

Hex Wrench 4mm

.............................................. 1

To adjust the gibs:

DISCONNECT MACHINE FROM POWER!

2. Loosen the jam nuts on the gib adjustment

set screws (see Figure 76).

3. Evenly adjust the set screws small amounts,

then test the results.

When you are satisfied with the gib adjust-

ment, re-tighten the jam nuts without turning

the set screws.

Re-check the gib adjustment. If necessary,

repeat this procedure.

Figure 76. Location of set screws and jam nuts

for adjusting gibs.

Gib

Adjustment

Set Screws &

Jam Nuts

Grizzly G1026 User Manual

Other manuals for Grizzly G1026