102
GB
Starting the Engine (Pic. 10)
Start the engine at least three me-
Ensure that the protective cap on the
thread cutter (see pic. 7, no. 14) has
been removed.
pic.10
41
40
11
42a
42
4
3
7
11
3
1. Set the On/O switch (40) on the swit-
ching element (23) to “On” .
2. For a cold start set the choke lever
(4) into position .
For a warm start leave the choke le-
ver (4) in position .
Warning! If there is any doubt,
seek help with the operation of
this equipment from a specialist in
an authorised service centre.
Putting on the Carrying Strap
(Pic. 9)
Always wear a shoulder strap
when working with the equipment.
before loosening the shoulder
strap. Risk of accidents.
1. Put on the carrying strap (28) and close
the strap clasp (38).
2. Adjust the strap so it ts tightly.
3. Adjust the strap so the spring clip (39) is
around 10 cm below the hip.
4. Fix the spring clip onto the lifting ring (9)
on the shaft tube of the equipment.
Unhook the equipment before start-
ing the engine and x it to the carry-
ing strap with the engine running.
pic. 9
28
38
39
9
To Next Page
Loading...
