Version 2.4 Page 33
FULL.PC (Full Security Access Code for Setup)
The FULL.PC (Full Access code) can be set to restrict access to Full Setup mode. This access
code is used to prevent unauthorized or accidental tampering in the indicator setup. The default
access code setting is 000000 that allows free access. Any other number will enable the access
code functions and restrict access. Refer to Accessing the Setup Mode on page 27 for more
information.
Range 000000 to 999999
Default: 000000
KEY.LOC (Front Panel Key Locking)
This item allows individual keys to be locked and unlocked. The display shows a dash (-) to
indicate that a key is locked (inactive) or characters for each key that is active (e.g. the characters
P12345 displayed). The letter P represents the [POWER] key and the numbers 1234 and 5
represent the remaining operation keys. The operation keys are numbered from the left with the
[ZERO] key being number 1.
Note: When the [POWER] key is locked, the indicator cannot be turned off from the front keypad.
Default: P12345 - All keys are unlocked (active)
KEY.FN (Key Functions)
The function of the [ f ] key can be selected here. Refer to Special Functions page 37 for details
of the available key functions.
Options are: NONE, COUNT, HOLD, LIVE.WT, TEST, UNITS, PEAK.H, SHOW.T
Default: NONE
AUT.OFF (Auto Power Off / Battery Operation)
The Model 250 can be set up to automatically power down after a period of no activity. Weight
motion, network communications or any press of the keypad is enough to keep the indicator
powered up. When operating on batteries the unit will turn off after 30 minutes of inactivity even if
set to NEVER.
Options are:
NEVER: Never power off automatically (Battery: powers down after 30 minutes)
1, 5,10 (time in minutes)
Default: NEVER
B.LIGHT (Backlight Operation)
Sets the operation of the backlight. When operating the backlight with batteries the brightness is
lowered automatically to conserve power and the backlight will automatically turn off after 10
seconds of inactivity. To turn on again, press the [POWER] key.
Options are:
OFF: Backlight is off
ON: Backlight is always on
Default: ON
WARNING
Be sure to remember your password. Reflashing the unit will not clear out the password. The indicator will
need to be sent back to the factory in order to regain access to the setup mode.
To Next Page
Loading...
