Version 2.4 Page 39
SHOW TOTAL (ACCUMULATION)
The SHOW.T function is used for product accumulation. The function key will be labeled
[TOTAL].
The [PRINT] key is used not only to print the current weight but also to add that weight to the
current total.
Press the [TOTAL] key to display count followed by the number of items in the total.
Performing an Accumulation
If the total weight is too large to display in six digits, the weight is shown in two sections labeled
with the upper six digits displayed before the lower six digits.
1. Access the weight mode.
2. Turn on the accumulation feature by holding the [POWER] and [PRINT] keys simultaneously
for 3 seconds. The display will show “ACC ON” when the accumulation mode is enabled and
“ACC OFF” when the accumulation mode is disabled.
3. Apply the weight to be accumulated (added to total) to the scale.
4. Press the [PRINT] key to add the applied weight to the total. A ticket will also be printed.
5. Continue steps 3 and 4 for each accumulation needed. If the application is legal for trade,
the weight must return to zero before another accumulation may be performed.
6. A long press of the [PRINT] key causes the total accumulated weight to be printed and then
cleared. Refer to page 52 for a sample ticket. The SERIAL:TYPE option must be set to
PRINT to activate this function.
To Next Page
