Page 34 250 Technical Reference
REM.FN (Remote Function)
This item allows the indicator to be triggered from a remote input. The remote input can be set to
have no function (e.g. NONE) or it can be set to mimic one of the front five panel key functions
(i.e. where KEY1=ZERO, KEY2=TARE, KEY3=GROSS/NET, KEY4=PRINT and
KEY5=FUNCTION).
The remote input can also be set to BLANK where, when the remote input is pressed and held,
the indicator displays dashes (i.e. - - - - - -) and the front five key functions are disabled. When
the remote input is released the indicator display and front key functions return to normal.
For the REM.FN to have any effect, the SERIAL:TYPE item must be set to KEY. Refer to TYPE
(Serial Output Type) below for more information.
Options are:
NONE: No function.
KEY1 to KEY 5: Mimic one of the front five function keys
BLANK: Display dashes (i.e. - - - - - -) and disable front key functions.
Default: NONE
BAT.VLT (Battery Voltage)
The indicator can be set to run with a variety of different batteries. When in the default setting of
PWR the indicator will always assume it has external power. In other battery modes the indicator
will always assume it is on battery power. Correct function of the low battery warning is
dependant on correct setting of the battery voltage.
Options are:
PWR: Never powered off battery
4.8 (250 & 250SS only), 9.6 (250X only),12, 24 (Battery Voltage)
Default: PWR
WD.LOC (Washdown Front Panel Key Locking) (250X only)
This feature locks the keypad during washdown. Enable this feature and save the change. Turn
the Model 250X off. At power up the display will prompt “KEY LOCK” and prompt to UNLOCK
PRESS KEY (1)POWER, (6)FUNCTION, (2)ZERO, (5)PRINT, (3)TARE, (4)GROSS/NET.
“PASS” will be displayed if the code was entered successfully and the weigh mode will be
accessed. If the wrong key is pressed or no key is pressed the unit will turn off.
SERIAL
Settings within this Group determine the serial and printing outputs. Refer to Automatic Weight
Output and Printing on page 51 for more information on serial configuration.
TYPE (Serial Output Type)
Sets the function of the first serial output. The port can be disabled or set to run as an automatic
output or a network device.
Options are:
NET: Network Communications.
AUTO.1: Enables 10 Hz automatic transmission using format 1. Refer to page 51.
AUTO.2: Enables 10 Hz automatic transmission using format 2. Refer to page 51.
PRINT: Enables printer driving. Refer to page 52.
MASTER: Send contents of LCD display to a remote display. Refer to page 53.
KEY: Enables the Remote Function setting (SPEC:REM.FN).
Default: NET
To Next Page
Loading...
