GSM M2BX - Siren Ring Time Setting; Alarm Delay Setting

Back
Enter
Zone 1
Back
Enter
Siren:1 min
Delay:Disable
Zone 1
19
System Settings
8. Siren Ring Time Setting
The siren will ring for 1 minute (default setting) when there is an alarm.
The ringing time can be set (0~5min) according to your need. 0 is
displayed as “disabled” on the screen. It means there will be no siren
sound when alarming
Fig 1: enter defense zone setting
Fig 2: enter siren time setting Fig 3: press ENTER to change
Fig 4: (this example)
Before setting, the siren rings for 1min when alarming;
After setting, the siren rings for 3min when alarming.
9. Alarm Delay Setting
Alarm delay: the main panel will make alarm call and the siren will ring
after the preset delay time.
Zone
Enter
Exit
Method: enter defense zone setting, press “2” or “8” to choose siren
enable, and then press ENTER to change the time.
Method: enter defense zone setting, press “2” or “8” to choose delay
enable or disable, and then press ENTER to confirm.
Operation figures:
Back
Enter
Back
Enter
Enter
Exit
Fig 4: (this example)
Before setting, zone 1 does not alarm in home arm status;
After setting, it will alarm when triggered in home arm status.
Fig 1: enter defense zone setting Fig 2: choose mode Fig 3: press ENTER to confirm
HOME: Disable
Disarmed: Disable
Zone 1 Zone 1
Disarmed: Disable
HOME: Enable
Zone
Enter
Exit
Back Enter Back Enter
Siren:3 min
Delay:Disable
time