GSM M2BX - Alarm Number Setting

10
System Settings
10. Alarm Number Setting
This system can store 6 alarm phone numbers. When alarming, it will
make alarm call to these numbers in order for three times
automatically, until someone gets through the call.
Method: enter phone number setting menu, press “4” or “6” to choose
serial number and then press ENTER. Input the number you want to
set, then press ENTER to save.
Operation figures:
Fig 1: enter phone number setting
Fig 2: choose serial NO.
Fig 3: input phone number
Fig 4: press ENTER to save
Fig 5: the 1st number is set
successfully
Phone 1
Back
Enter
No number
Delete
Back
Save
123456789
Input phone number
Phone 1
Phone 1
Save completed
Phone number
Exit
Enter
Phone 1
Back
123456789
Delete
Enter
Back
Enter
Back
Enter
Enter
Exit
Zone 1Zone 1
Fig 1: enter defense zone setting
Fig 2: choose delay status
Fig 3: press ENTER to confirm
Zone
Operation figures:
Siren: Disable
Siren: Disable
Delay: Enable
Delay: Disable
Fig 4: (this example)
Before setting, the panel makes alarm and the siren rings immediately when zone 1 is triggered;
After setting, alarm will be after the preset time. (set the delay time under [system setting])
Exit
Enter Back Enter