4
Initialization
Chapter 3. Initialization
Correct initiation of the main panel is important to its normal working
and lifespan.
1. Connect the wired accessories that you need.
2. Insert SIM card.
3.
Chapter 4. System Settings
All the settings have to be done in setting status. Press 2/8/4/6 to turn
up/ down/ left/ right.
1. Enter Settings
Turn on the power switch.
Enter setting status: in the state of disarm, input 6-digit password
(system default: 123123), and then press ENTER. The main panel
makes a “beep” and SET indicator lights on. The screen shows remote
controller setting.
Please pay attention to the direction arrow marked
on the slot: “LOCK” “OPEN”. Do not insert or take
out the SIM card when the main unit is power on.
6. SIM card slot:
Connect the power adaptor. The main panel will start self-inspection
and the POWER indicator LED will turn on. If this LED does not
light on, you need to restart the panel. Please do it at least 10
seconds later as repeated power on and off in short time is bad to
the panel's service life.
4.
5.
The signal icon and SIM card icon on the LCD screen will flash when
searching signal. And the SIM card icon will disappear after
searching GSM network successfully.
6.
Check the GSM signal icon on the screen. Normal performance will
be affected when the signal has less than 3 bars. Please put the
main panel at the place with good GSM signal.
To Next Page
Loading...
