Remote control operation: press arm button [ ] on the remote
control.
Main panel operation: press [ARM]. The system will enter arm status
after the delay time (default: 60seconds)
Main panel operation: press [STAY].
Use main panel keypad to press [STAY]. The screen will display
“system armed”.
Remote control operation: press home arm button [ ] on the remote
control.
Home arm means part of the defense zones are in arm status. When
there's someone at home, it is recommended, for safety purpose, to
enable some of the detectors (such as sensors for door, window,
balcony, etc), and disable the others (such as sensors for the hall or
some places easy to be triggered by person at home).
2. Home Arm
SMS operation: send “operate password#1#” (default operate
password: 123456)
nobody at home, it is required to set all the detectors working. Any
detection source (such as thief, fire, or gas leakage) trigger the
detector, the alarm system will make alarm.
Use main panel keypad to press [ARM]. You will hear beep sound
(within the preset arm delay time). There will be one beep per each
second until the screen displays “system armed”.
Operation Instructions
27
System armed
11:49 11/26/2013
To Next Page
Loading...
