GSM M2BX - Wireless Siren Encryption; Change Operate Password

17
System Settings
Method: “wireless control” menu, and then “address” menu. Input 6
numbers randomly and then save it. (The default address is 999999.)
Operation figures:
21. Wireless Siren Encryption
The signal used to code with the wireless siren is sent from the internal
transmitter of the main panel. The signal address of all this model from
our company are the same. If you and your neighbor both are using
this model, the alarm signal from your neighbor may cause your siren
sound. So it is recommended to set the wireless siren with another
address to avoid the interference.
Fig 1: enter wireless control
menu
Fig 2: control menu
Fig 3: press “6” to choose
wireless siren
Fig 4: press SAVE to save
Wireless Control
Enter
Exit
Back
Enter
Address
Wireless Control
Back
Save
123456
RF address set
Please input
Operate password is used for daily use (disarm or remote control).
System default is 123456.
22. Change Operate Password
Method to change this password: enter “settings” menu, and then
“operate password”. Input the 6-digit password you want to set, and
save it.
Control: Enable
Save completed