Figure 5-7 shows a block diagram of the APS-1102A signal sources.
Figure 5-7. Block Diagram of Signal Sources
Operation steps
Select in the SET menu.
See “3.4.2 Setting output mode”, for how to select the output mode.
5.3.2 Output voltage range setting
Select 100 V or 200 V as the output voltage range.
The output voltage range cannot be changed when output is on.
The output voltage setting, current limiter setting, etc., vary according to the output voltage range setting.
See “Table4-2. Setting Range Options for Various Output Voltage Ranges”.
Output voltage range settings are retained for each operation mode (AC and AC+DC).
Operation steps
To set the output voltage range, select in the SET menu.
For description of output voltage range settings:
See “3.4.3 Setting output voltage range”.
See “4.1.3 Setting the output voltage range”.
To Next Page
Loading...