GW Instek APS-1102A - Remote-Related External Control Errors; Table7-8. Remote Error Message List

7 TROUBLESHOOTING
APS-1102A
7-11
7.2.5 Remote-related external control errors
Table7-8 lists remote-related external control error messages.
Table7-8. Remote Error Message List
No.
Message Text
Cause
0
“No error”
No error.
100
“Command error”
Command was recognized as invalid due to any cause.
(General command error)
102
“Syntax error”
Command was recognized as invalid due to reception of
undefined command or parameter.
200
“Execution error”
Error occurred when executing the command due to any cause.
(General execution error)
222
“Data out of range”
Error occurred when executing the command due to out of range
parameter.
350
“Too Many Errors”
New errors cannot be retained due to error queue overflow.
1
“Invalid with output on”
Error occurred when executing the command because the output
relay was on.
2
“Invalid with output off”
Error occurred when executing the command because the output
relay was off.
3
“Invalid in this mode”
Error occurred when executing the command due to inappropriate
operation mode.
4
“Under Busy State”
Error occurred during execution of the command, because the
device is busy state.
5
“Out of Limiter”
Error occurred during execution of the command because limiter
value was exceeded.
6
“Invalid in this frequency”
Error occurred when executing the command due to inappropriate
oscillation frequency setting.
7
“Out of Input Signal
frequency”
Error occurred when executing the command due to out of the
external synchronization frequency range.
8
“Under Warning State”
Error occurred when executing the command because device was
operating in protected mode.