TST?
This returns the self test results. In this device, “0” is always returned.
Syntax: TST?
Parameters: None
Query example: TST?
Response format: <NR1>
Response example: 0
WAI
This is to prohibit the device from executing any subsequent command until all the operations (
※
)
are completed.
Syntax: WAI
Parameters: None
Command example: WAI
Response format: None
Response example: None
※
“Operations” means execution process of any commands in the following.
Output mode setting [SOURce:]MODE
Output range setting [SOURce:]VOLTage:RANGe
Output relay control OUTPut[:STATe]
Sequence execution PROGram[:SELected]:EXECute
Memory recall *RCL
Device reset *RST
To Next Page
