GW Instek APS-1102A - Page 7

Contents
APS-1102A
v
4.1.2 Selecting an output mode (AC+DC-INT mode) ......................................... 4-3
4.1.3 Setting the output voltage range ............................................................... 4-5
4.1.4 Setting the output voltage ......................................................................... 4-7
4.1.5 Setting output frequency of superimposed AC .......................................... 4-9
4.1.6 Setting superimposed AC waveform ....................................................... 4-10
4.1.7 Using the measurement function ............................................................. 4-11
4.2 Measurement of Inrush Current ................................................................... 4-15
4.2.1 Inrush current ......................................................................................... 4-15
4.2.2 Set phase at output on ........................................................................... 4-16
4.2.3 Set measurement display to peak value ................................................. 4-17
4.2.4 Reset the peak current hold value .......................................................... 4-18
4.3 Measurement of Harmonic Current .............................................................. 4-20
4.4 Using the Sequence Function ...................................................................... 4-22
4.4.1 Sequence operations ............................................................................. 4-22
4.4.2 Sequence settings .................................................................................. 4-29
4.4.3 Programming sequences ........................................................................ 4-31
4.4.4 Control of sequence operations .............................................................. 4-37
4.4.5 Clear sequence memory......................................................................... 4-39
4.4.6 Example of sequence operation settings ................................................ 4-40
4.4.7 Execution of sequence operations .......................................................... 4-44
4.5 Control Using External Control I/O Connector ............................................. 4-48
4.6 Output of Arbitrary Waveforms ..................................................................... 4-49
4.7 Synchronize the Output with External Signal ............................................... 4-51
4.7.1 External signal synchronization .............................................................. 4-52
4.7.2 Line synchronization .............................................................................. 4-54
4.8 Using Memory Functions ............................................................................. 4-55
4.9 Amplification of External Signal ................................................................... 4-58
4.10 Adding External Signals and Internal Signals .............................................. 4-62
5. MENUS .............................................................................................................. 5-1
5.1 Screen Configuration ..................................................................................... 5-3
5.1.1 Status icons .............................................................................................. 5-5
5.1.2 Warnings and error messages .................................................................. 5-6
5.1.3 Sequence display ..................................................................................... 5-6
5.2 Basic Operations ........................................................................................... 5-7
5.2.1 Menus ...................................................................................................... 5-7
5.2.2 Navigating the menu tree ....................................................................... 5-12
5.2.3 Numerical value input operations ........................................................... 5-13
5.2.4 Selection and input operations that require confirmation ........................ 5-13
5.2.5 EXEC input ............................................................................................ 5-14
5.2.6 Shortcut keys ......................................................................................... 5-14
5.3 SET Menu ................................................................................................... 5-15
5.3.1 Output mode setting ............................................................................... 5-16
5.3.2 Output voltage range setting .................................................................. 5-17
5.3.3 Setting output voltage ............................................................................ 5-18
5.3.4 Setting output frequency ........................................................................ 5-19