GW Instek GDS-1062A - Using the Vertical Cursors

MEASUREMENT
53
Moving the
horizontal
cursors
To move the left cursor, press
X1 and then use the Variable
knob.
To move the right cursor, press
X2 and then use the Variable
knob.
To move both cursors at once,
press X1X2 and then use the
Variable knob.
Remove cursors
Press Cursor to remove the
onscreen cursors.
Cursor
Using the vertical cursors
Procedure
1. Press the Cursor key.
Cursor
2. Press X↔Y to select the
vertical (Y1&Y2) cursor.
3. Press Source repeatedly to
select the source channel.
Range
CH1, 2, MATH
4. The cursor measurement results will appear in
the menu.
Parameters Y1
Voltage level of the upper cursor
Y2
Voltage level of the lower cursor
Y1Y2
The difference between the upper and
lower cursor
∆ : V
The voltage difference (Y1-Y2).
GDS-1000A Series User Manual
54
Moving the
vertical cursors
To move the upper cursor,
press Y1 and then use the
Variable knob.
To move the lower cursor,
press Y2 and then use the
Variable knob.
To move both cursors at once,
press Y1Y2 and then use the
Variable knob.
Remove cursors
Press Cursor to remove the
onscreen cursors.
Cursor