CONFIGURATION
83
USB Port Interface
The USB port can be set to auto detect, however occasionally the
USB host type cannot be detected. The USB Port function allows the
USB host type to be manually or automatically set.
USB connection PC / Printer end
Type A, host
GDS-1000A end
Type B, slave
Speed
1.1/2.0 (full speed)
Procedure
1. Connect the USB cable to
the USB slave port on the
GDS-1000A.
2. Insert the other end of the
USB cable into the PC or
Printer USB port.
3. Press the Utility key.
Utility
5. Press USB Port repeatedly to
set the host device .
Range
Printer, PC, Auto Detect
GDS-1000A Series User Manual
84
Remote Control Interface
The Remote control interface section describes how to set up the
USB interface for PC connection. Remote control command details
are described in the GDS-1000A Programming Manual. Note that
printing to a PictBridge compatible printer and remote control
cannot be supported at the same time as the same USB port is used.
USB connection PC / Printer end
Type A, host
GDS-1000A end
Type B, slave
Speed
1.1/2.0 (full speed)
Procedure
1. Connect the USB cable to
the USB slave port.
2. The USB port may need to
be configured if the USB
port is not automatically
detected.
Page83
3. When the PC asks for the USB driver, select
dso_cdc_1000.inf (Windows XP) or
dso_vista_cdc.inf (Vista 32bit) which are
downloadable from the GW website,
www.gwinstek.com
, GDS-1000A product
corner.
4. On the PC, activate a terminal application such
as MTTTY (Multi-Threaded TTY). To check the
COM port No., see the Device Manager in the
PC. For WindowsXP, select Control panel →
System → Hardware tab.
To Next Page
Loading...
