GW Instek GDS-1062A - Saving the Panel Settings; Saving the Waveform

SAVE/RECALL
97
Saving the panel settings
Procedure
1. (For saving to an external
SD card) Insert the card into
the slot.
2. Press the Save/Recall key
twice to access the Save
menu.
Save/Recal
l
Save/Recal
l
3. Press Save Setup.
4. Press Destination repeatedly
to select the saved location.
Use the Variable knob to
change the internal memory
location (S1 ~ S15).
VARIABL
E
Memory
Internal memory, S1 ~ S15
SD card
External card, no practical
limitation for the amount of file.
When saved, the setup file will be
placed in the root directory.
5. Press Save to confirm
saving. When completed, a
message appears at the
bottom of the display.
Note
The file will not be saved if the
power is turned off or the SD card is
disconnected before completion.
GDS-1000A Series User Manual
98
File utilities
To edit SD card contents
(create/ delete/ rename files
and folders), press File Utilities.
For details, see page91.
Saving the waveform
Procedure
1. (For saving to an external
SD card) Insert the card into
the slot.
2. Press the Save/Recall key
twice to access the Save
menu.
Save/Recal
l
Save/Recal
l
3. Press Save Waveform.
4. Press Source. Use the
Variable knob to select the
source signal.
VARIABL
E
CH1 ~ CH2
Channel 1 ~ 2 signal
Math
Math operation result (page55)
RefA, B
Internally stored reference
waveforms A, B
5. Press Destination repeatedly
to select the file destination.
Use the Variable knob to
select the memory location.
VARIABL
E
Memory
Internal memory, W1 ~ W15