GW Instek GPP-3060 - Page 175

REMOTE CONTROL
175
Example
:TRIGger:IN D0,ON
Enabled trigger input function of the D0 data line.
Command
:TRIGger:IN[:ENABle]?{D0|D1|D2|D3|D4}
Function
Queries the state of the trigger input function of the
specified data line.
Example
:TRIGger:IN? D0
Returns the state of the trigger input function of the
D0 data line.
Command
:TRIGger:IN:RESPonse{D0|D1|D2|D3|D4},{ON|
OFF||TOGGLE|POWER|CV|CC|CR|IND|SER
|PAR }
Function
Sets the output response from the trigger input of
the specified data line.