GW Instek PEL-3111 - Create a Program Chain

FUNCTION MENU
123
Create a Program Chain
Note
Before creating a program chain, make sure a number
of programs have already been saved. These will be
used to create the program chain.
Chain Setting
Display Overview
Select
Start
LOADRS232
01/Oct/2017
Off
P03 Off
P02 Off
P04
P01
Start
Off
P01
Program Chain Set
Starting program
for the chain
Recall
Default
Previous
Menu
Operation
1. Press
FUNC
> Program[F1] > Chain[F2].
 It may be necessary to load the programs from
Setup memory if they were not created in the
current session.
2. If Start is not selected yet, press Select Start[F1]
and select which program will be used to start
the program chain.
Start:
P01 - P16
3. Select P01 and choose which program will be
linked to P01.
 Selecting OFF will end the chain after P01.
 Selecting P01 will create an infinite chain.
 Chains need not be linked in sequential order.
P01:
OFF, P01 - P16
4. Repeat step 3 for any remaining programs in
the chain.