GW Instek PEL-3111 - Running a Program or Chain

PEL-3000(H) User Manual
124
5. Press Save to save the program chain to internal
memory.
6. Pressing Recall Default[F4] will reset the chain to
the default settings. See page 213 for details.
 Recall Default[F4] will essentially clear the
program chain.
Running a Program or Chain
Description
A program or program chain is run the same way
as a normal load.
Operation
1. Press
FUNC
> Program[F1].
2. Turn program mode on by setting Program[F1]
to On.

PROG
will appear at the top of the display when
Program is On.
3. Turn the load on.
 The program/chain starts immediately.
 The
PROG
icon turns orange when the load is
turned on.
4. When a program/chain is running the screen
displays which program, step and memory is
currently active.
 Press Pause[F1] to suspend a test, press
Continue[F1] to resume.
 Press Next[F2] to run the next step if its Run
setting was set to Manual.
5. When a program/chain has finished running, a
list of the Go-NoGo results for each step are
displayed.
 Press Exit[F5] to exit.