GW Instek PEL-3111 - Index

INDEX
253
INDEX
Accessories ................................. 11
Advanced configuration
Alarm tone .....................................92
Auto Load ......................................77
Control settings .............................93
Count time .....................................75
Cut off time ...................................76
Display ...........................................92
Dyna. Time ....................................68
Go-NoGo .......................................95
Language .......................................93
Load Off (Mode) ...........................78
Load Off (Range) ..........................78
OCP ................................................82
OPP ................................................83
OVP ................................................87
Protection settings ........................82
Short enable/disable ....................64
Short(safety) ..................................62
Soft start .........................................72
Speaker ..........................................91
Step resolution ..............................79
System settings .............................91
Trigger ...........................................93
UVP ................................................84
Von delay.......................................75
Von latch ........................................74
Von voltage ...................................73
Alarm Tone ................................. 92
Analog connector
pin assignment .................... 166, 167
Caution symbol ............................ 3
CC Response speed ................... 71
Cleaning the instrument ............. 5
Conventions ............................... 45
CP Response speed .................... 71
CR Response speed ................... 71
CV Response rate ....................... 70
Declaration of conformity251, 252
Default settings ........................ 213
operation ..................................... 110
User .............................................. 110
Display diagram ......................... 25
Disposal instructions ................... 6
Disposal symbol ........................... 3
Dynamic mode frequency ......... 68
EN61010
Measurement category .................. 4
Pollution degree ............................. 6
Environment
Safety instruction ........................... 5
External control
Alarm ........................................... 183
Alarm status ............................... 184
Current monitor ................. 186, 187
Current status ............................. 181
Load status .................................. 180
Overview..................................... 166
Resistance control ...................... 173
Short control ............................... 184
Trigger ......................................... 183
Trigger signal output ................. 185
Turning the load on ................... 178
Voltage control ........................... 168
External control ........................ 165
FAQ ............................................ 206
Fast Sequence
Configuration ............................. 140
Data edit ...................................... 141
Overview..................................... 136
Run .............................................. 143
File Utility ................................. 107
Firmware update........................ 43
First time use instructions ......... 26
Front panel diagram .................. 14
Function
Count Time ................................. 116
Load ............................................. 114