GW Instek PEL-3111 - CV, +CV Mode Response Speed

PEL-3000(H) User Manual
70
CV, +CV Mode Response Speed
Description
The response speed setting is the response speed
for the negative feedback control of the load
current when used in CV, +CV mode. Response
speed settings are only applicable to CV, +CV
mode.
 A response speed that is too fast could cause
the unit to be unstable.
 Reducing the response speed can improve
stability.
Operation
1. Make sure the load is off.
2. Press
Main
. Make sure the unit is in CV
mode by using the Mode[F1] soft-key.
3. Select the response speed with the Response[F4]
soft-key.
Range:
Slow, Fast (Fast, 6, 5, 4, 3, 2, 1, slow)
CV mode: The response speed settings
Fast, 6, 5, 4 are all the same
for CV mode.
+CV mode: The response speed settings
5 and 4 are the same for CV
mode. The response speed
settings Slow and 1 is the
same.