GW Instek PEL-3111 - Running a Normal Sequence

FUNCTION MENU
133
 Time
 LOAD
 RAMP
 TRIG OUT
 PAUSE
6. If you wish to edit a previously inserted
point/step, use the Step parameter.
 Steps can only be selected after they have
already been inserted.
Steps
0001 - 1000
7. The currently selected step can be deleted
using the Delete Point[F2] function.
8. After all the steps for the sequence are
complete, press Save[F3] to save the steps.
Data Edit for Normal Sequence configuration is
complete.
 Go to Timing Edit for Normal Sequences to
edit the sequence. Page 130.
 Go to Running a Normal Sequence to run the
normal sequence. Page 133.
Running a Normal Sequence
Description
Unlike a normal static or dynamic load, a load
created with the Normal Sequence function is
turned on by pressing the Shift and Load keys.
Operation
1. Press
FUNC
> Normal Sequence[F2].
2. Turn normal sequence mode on by setting
N. Seq.[F1] to On.

NSEQ
will appear at the top of the display when
N. Seq. is On.